ARC S7 Polymer Composite

High Temperature and Chemical Resistant Novolac Vinyl Ester Coating

A low VOC, novolac vinyl ester based, sprayable protective barrier coating for high temperature, chemical exposures where thermal cycling conditions may be present. ARC S7 industrial coating is designed to:

Resist thermal cycling conditions up to 180°C (350°F)
Resist a wide range of inorganic as well as organic acids and hydrocarbon based chemical compounds
Easily apply by airless spray system

Chemical resistant polymer matrix
- Resists a broad spectrum of organic and inorganic acid
- Resistant to cold wall delamination
Incorporates fine-graded sizes of reinforcements
- Permeation resistant
Toughened resin structure
- Resists cracking and disbondment under thermal cycling conditions
- Survives rapid decompression
Low mixed viscosity
- Easy to apply by conventional airless spray
High dielectric resistivity
- Allows user to inspect with high voltage spark testing per NACE SP0188
Cured films have low surface energy
- Reduces particle attachment

500 μm (20 mil) WFT yields 400 μm (16 mil) DFT

14 liter kit covers 28 m2 (300 ft2)

ARC S7 is recommended to be applied as a 2-coat system at 375 – 500 μm (12 – 15 mil) wft1) per coat. The recommended total dft2) is 650 -850 μm (25 – 30 mil)

Note: Components are pre-measured and pre-weighed.

Each kit includes mixing and application instructions.

1.) wft = wet film thickness

2). dft = dry film thickness

Maintain transport temperature below 24°C (75°F.)

Available Colors

Red and White

Chemical resistant polymer matrix
- Resists a broad spectrum of organic and inorganic acid
- Resistant to cold wall delamination
Incorporates fine-graded sizes of reinforcements
- Permeation resistant
Toughened resin structure
- Resists cracking and disbondment under thermal cycling conditions
- Survives rapid decompression
Low mixed viscosity
- Easy to apply by conventional airless spray
High dielectric resistivity
- Allows user to inspect with high voltage spark testing per NACE SP0188
Cured films have low surface energy
- Reduces particle attachment

500 μm (20 mil) WFT yields 400 μm (16 mil) DFT

14 liter kit covers 28 m2 (300 ft2)

ARC S7 is recommended to be applied as a 2-coat system at 375 – 500 μm (12 – 15 mil) wft1) per coat. The recommended total dft2) is 650 -850 μm (25 – 30 mil)

Note: Components are pre-measured and pre-weighed.

Each kit includes mixing and application instructions.

1.) wft = wet film thickness

2). dft = dry film thickness

Maintain transport temperature below 24°C (75°F.)

Available Colors

Red and White

PT. PANCAMAS PUTRAMANDIRI

500 μm (20 mil) WFT yields 400 μm (16 mil) DFT

Available Colors

500 μm (20 mil) WFT yields 400 μm (16 mil) DFT

Available Colors

Need more information?

About

Contact

Submission Form to Request Catalog For Product: